Aldo
08-31-2006, 06:21 AM
I posted a tip in teen2233's "Door Frame" thread that may be of value to many others who install new (not replacement) locks or knobsets. The tip, imho, is worthy of mention to those who did not see that reply.
Properly placing the latch hole is tricky, at best. You can make it an absolute no-brainer by applying paint to the outer surface of the latch. Retract the latch, close the door, release/open the latch, and open the door. This will leave a paint mark on the jamb which is precisely where you need to drill the hole.
Properly placing the latch hole is tricky, at best. You can make it an absolute no-brainer by applying paint to the outer surface of the latch. Retract the latch, close the door, release/open the latch, and open the door. This will leave a paint mark on the jamb which is precisely where you need to drill the hole.